Burkert 8693 - Inputting the Input Signal; Inputting the Operating Mode of the Pneumatic Actuator

57
Type 8692, 8693
english
Start-up, operation
position controller Type 8692
2.4.2 Inputting the operating mode of the pneumatic actuator
ACTUATOR - Operating mode of the actuator
The operating mode of the pneumatic valve actuator used in combination with the positioner can be input in this menu option.
The operating mode of the actuator has been preset at the factory.
SF A and SF B: single-acting
SF I: double-acting
The control function of the actuator can be found on the rating plate.
ACTUATOR
ENTER
SELEC
SINGLE
EXIT
DOUBLE
single-acting•
double-acting•
Fig. 2: Operating structure of ACTUATOR
2.4.3 Inputting the input signal
INPUT - Selected unit input signal
Under this menu option input the unit signal used for the set-point value.
→
INPUT
SELEC
4-20 mA
EXIT
ENTER
0-20 mA
0-10 V
0- 5 V
Current 4 – 20 mA•
Current 0 – 20 mA•
Voltage 0 – 10 V•
Voltage 0 – 5 V•
Fig. 3: Operating structure of INPUT