Burkert 8693 - INTERFACES OF THE POSITIONER FOR THE MODELS WITH CABLE GLAND

25
Type 8692, 8693
english
Description of System
Hierarchical control concept for easy control on the following levels
Process control On this level switch between AUTOMATIC and MANUAL mode.
Configuration and parameterisation On this level specify certain basic functions during start-up and,
if required, configure additional functions
5 INTERFACES OF THE POSITIONER FOR THE MULTIPOLE MODEL
Inputs for position or
process set-point value
4 – 20 mA
0 – 20 mA
0 – 10 V
0 – 5 V
Input for process
actual value
4 – 20 mA
Frequency
Pt100
Binary input
24 V DC
Positioner
(Multi-pole variant)
2 binary outputs
Initiator 1
Analogue
position feedback
Inputs Outputs
Sup- ply
Operation
Fig. 10: Interfaces for the multipole model
The positioners Type 8692 and Type 8693 are 3-wire devices, i.e. the power (24 V DC) is supplied separately from the
set-point value signal.