Burkert 8693 - SAFETY INSTRUCTIONS

52
Type 8692, 8693
english
Start-up, operation
position controller Type 8692
4.3 Auxiliary functions .............................................................................................................................................................................................66
4.3.1 CHARACT Select the transfer characteristic between input signal (position set-point value) and stroke .
67
4.3.2 CUTOFF Sealing function for the position controller Type 8692 ...................................................................... 71
4.3.3 DIR.CMD Effective sense of direction of the position controller set-point value ......................................... 72
4.3.4 DIR.ACT Effective sense of direction of the actuator .......................................................................................... 73
4.3.5 SPLTRNG Signal split range ..................................................................................................................................... 74
4.3.6 X.LIMIT Lmits the mechanical stroke range .......................................................................................................... 75
4.3.7 X.TIME Limiting the control speed ........................................................................................................................... 76
4.3.8 X.CONTROL Parameterisation of the position controller ................................................................................... 77
4.3.9 SECURITY Code protection for the settings ........................................................................................................ 78
4.3.10 SAFEPOS Input the safety position ........................................................................................................................... 79
4.3.11 SIG-ERROR Configuration of signal level fault detection .................................................................................... 80
4.3.12 BINARY-IN Activation of the binary input .................................................................................................................. 81
4.3.13 OUTPUT (option) Configuring the outputs ................................................................................................................ 82
4.3.14 CAL.USER Calibrating the actual value display and the inputs for the position set-point value ................. 86
4.3.15 SET.FACTORY Resetting to the factory settings .................................................................................................... 87
4.3.16 SER. I\O Settings of the serial interface ................................................................................................................... 88
4.3.17 EXTRAS ........................................................................................................................................................................... 89
4.3.18 SERVICE ......................................................................................................................................................................... 89