Burstner Premio - Page 112

112 Premio/Averso - 13/14 - Ausgabe 09/13 - 2354619 - BUE-0048-12EN
Appliances
9
Switching off:  Turn the control knob on the heater to "0". The automatic ignition is
switched off simultaneously.
 Close the gas isolator tap "Heater" and the regulator tap on the gas bottle.
Switching on the fan:
 Set the rotary switch (Fig. 141,2) to the required operating mode.
Switching off the fan:
 Turn the rotary switch (Fig. 141,2) to "0".
Automatic ignition The automatic ignition ignites until the gas is burning or the battery in the auto-
matic ignition is empty.
Changing the battery on the
automatic ignition:
 Ensure that the heater is switched off and cooled down.
 Remove heater cover (Fig. 142,2). To do this, press the two locking levers
(Fig. 142,1) to the outside at the same time and tip the cover forwards.
 Lift the heater cover out of the bottom brackets and remove it.
 Push battery chamber cover (Fig. 143,2) on the automatic ignition
(Fig. 143,1) upward.
 Remove the old battery out of the battery chamber of the automatic ignition.
 Insert a new battery (Fig. 143,3) of the same type, correctly aligned (+/-),
into the battery chamber of the automatic ignition. Only use temperature
resistant (+70 °C) and leak-proof Mignon batteries.
 Close the battery chamber cover on the automatic ignition.
Switch position Operating mode Function
Fan operating modes
A Automatic The required fan output is regulated
electronically
M Manual The fan output is set manually using the
knob (Fig. 141,1)
Booster level The fan works at maximum output (for
maximum air flow)
Fig. 142 Removing heater cover Fig. 143 Automatic ignition