21Premio/Averso - 13/14 - Ausgabe 09/13 - 2354619 - BUE-0048-12EN
Before the journey
3
Couple caravan.
Use the connection cable to connect the caravan to the towing vehicle. The
caravan control system starts a self test. The control LED (Fig. 5, 1) on the
caravan lights up red for about 3 seconds.
Check whether the control LED lights up green after the self test. The car-
avan control system is now active.
3.7 Manoeuvring system (special equipment)
Using the manoeuvring system (Mover), the vehicle can be moved without any
other aids.
Fig. 5 Control LED
1 Control LED
X No persons are to remain inside the caravan while it is being manoeu-
vred.
X No persons (in particular children) are to remain inside the manoeuvring
area while manoeuvring.
X In the event of malfunctions, apply the handbrake.
X Do not use the manoeuvring system as a handbrake.
X Store the remote control in a safe place inaccessible to children.
X Always swivel the drive rollers away from the tyres before commencing
a journey. If the drive rollers are swivelled onto the tyres during the
journey, the tyres could burst.
Z Before manoeuvring, check the tyres and drive rollers and if necessary,
remove any sharp stones or similar objects.
Z When manoeuvring on a slope, make sure the drawbar is facing downhill.
This will prevent the vehicle from tilting backwards.
Z Do not store sensitive devices like cameras of DVD players directly next to
the control device or the cable. The manoeuvring system generates elec-
tromagnetic fields that can damage such devices.
Z When manoeuvring, the interval between the remote control and the
middle of the vehicle may be a maximum of 10 meters.
Z After switching off the manoeuvring system via the remote control, the con-
trol remains in stand-by mode. To shut the manoeuvring system down alto-
gether, it must be disconnected from the battery.
Z After manoeuvring is complete, pull the 13-pin plug from the safety socket.
The living area battery can otherwise lose its charge.
Z If both brake lights are defective, the circuit of the safety socket is not
closed and the manoeuvring system will not work.
To Next Page
Loading...
