Non-Coded Messages
Global Message Description
Battery Service Limit
Reached
Reset the Service Counter, (see To set the battery service
counter, page 62)
BatteryShop Mode
Wait
Analyzer is waiting for input from BatteryShop software. If the
unit is not connected to BatteryShop, disable the Serial Port,
(see Connecting to BatteryShop or a Printer, page 63)
Calibration Error The short between terminals may have disconnected during
calibration. Redo the calibration.
C-Code Locked C-Code is locked and cannot be edited. Use an unlocked C-Code.
Delete and re-enter the C-Code to remove the locked C-Code.
Internal Error LCD memory is full. Press the Esc key to clear the buffer and
restart the analyzer. Services may resume.
N/A Not Applicable. QuickTest or OhmTest has not yet been
completed.
N/R Not readable. QuickTest could not determine the SoH for the
battery. In most cases, the resistance may not be within
acceptable limits.
NULL CODE See Code 211 (N
ULL
C-C
ODE IN
A
DAPTER
) in the next section.
Optimizing Matrix
Database
The QuickTest matrix is being built or generated after the Learn
program is complete. QuickTest results are compiling. Wait for a
few seconds to clear.
Unable to Print Printer port is disabled.
Serial Port and USB Port may be sharing the same printer
setting. Set the serial or USB port to another device or set it to
Disabled, (see Connecting to BatteryShop or a Printer, page 63)
To Next Page
Loading...
Need help?
General