3. Press
5
or
6
to scroll to SOUND CHECK and then press ENTER.
4.
Press 5 or 6 to scroll to the event and press
ENTER
to hear the sound.
5.
Repeat step 4 to hear other sounds assigned to the events.
6.
Press
ESC
twice to return to the global display.
Voltage Display
Voltage can display either for the entire battery (terminal voltage) or individual cell voltage
(V/Cell). If voltage display is set to V/cell (this is the default), multiply the displayed
voltage by the number of cells in the battery to find the voltage for the battery.
On some NiCd and NiMH batteries, manufacturers may rate their batteries based on
1.25V/cell rather than 1.2V/cell. This can also be set on the analyzer (see Battery Voltage
(Volts), page 43).
To set the voltage display mode
1. From the global display, press
MENU
.
2. Press
5
or
6
to scroll to OPTION CONTROLS and then press ENTER.
3.
Press 5 or 6 to scroll to
VOLTAGE DISPLAY
and then press
ENTER
.
4.
Press 5 or 6 to scroll to the required setting:
YES
sets the Cadex analyzer to display the voltage of individual cells within the battery
(V/Cell).
NO
sets the Cadex analyzer to display the terminal voltage for the battery as a whole
(Volts).
5.
Press 4 or 3 to move to the NiXX field.
6.
Press 5 or 6 to select 1.20 or 1.25 volts per cell to display for NiCd and
NiMH batteries.
7.
Press
ENTER
.
8.
Press 5 or 6 to scroll to
YES
to accept changes and press
ENTER
.
To Next Page
Loading...
Need help?
General