Advanced Programs
Advanced programs include OhmTest; RunTime; Self-Discharge; Life-Cycling; Discharge
Only; Extended Prime; QuickLearn (Q-Learn); Learn; Boost and the four programmable
custom programs. Unlike basic programs, some advanced programs have settings that
can be edited.
Program Does this Is used for this
Self-Discharge
Reads fully charged battery
capacity; recharges and reads
the capacity after a
programmable wait period.
Identifying batteries that may have
good capacity but have high self-
discharge.
Life-Cycle This is a destructive test that
continuously cycles a battery
until it fails.
Continuously cycles battery until
capacity drops below target
capacity. Displays initial and final
capacity, OhmTest result.
Verifying battery life cycle. For
example, take a sample of batteries to
determine the Life Cycle of an entire
batch of batteries.
Estimating performance time.
Discharge Only
(DCHOnly)
Discharges a battery to its end-
of-discharge voltage.
Determining residual capacity of
battery.
Preparing batteries for storage.
Determining battery performance
under load.
Extended
Prime
Applies a 16-hour trickle charge,
followed by cycling to obtain
peak capacity.
Preparing new batteries or batteries
that have been in extended storage
for use.
OhmTest Tests internal resistance. Passes
or fails the battery based on the
target resistance.
Checking battery condition.
Determining if the battery needs to be
analyzed further.
RunTime Simulates a 5/5/90 discharge.
Programmable time and
discharge rates per phase.
Testing battery runtime for
communications equipment.
To Next Page
Loading...
Need help?
General