a. if the battery’s capacity is 100%. If a battery’s capacity is less than 100%, it will
give erroneous results.
b. If the battery has been used (ie. excited) in the last 24 hours.
c. On custom adapters only. Universal adapters such as the Universal Alligator Clips
Adapter (07-110-0115), the Claw (07-110-0170) and the FlexArm (07-110-
0180) are NOT recommended. These adapters will give inaccurate results due to
resistance errors.
Q-Learn should only be used once. For more accurate results, run the Learn program on
three different batteries with varying capacities.
Q-Learn is available only on 16K Battery Adapters. ‘16K’ is marked on the rear label of
the adapter.
Q-Learn and QuickTest cannot be used with the following batteries:
o SLA batteries greater than 2Ah (2000mAh).
o 1-cell (1.20V) and 2-cell (2.40V) NiCd and NiMH batteries.
o Batteries with resistance above 800m? (as measured by OhmTest). It is
advisable to run OhmTest on any battery that is run through the Q-Learn
program.
o
Batteries that disconnect, reset or give failures while running the Learn or Q-
Learn programs.
o Batteries that cannot accept a charge rate and discharge rate of at least 1.00C.
These batteries tend to give errors if they are serviced on the analyzer using the
Auto or Prime programs.
Q-Learn Procedure
Calibrate the adapter and ensure that the C-Code for the battery is correct. Take several
batteries with 100% capacity or over. Confirm the capacity by servicing the batteries on
the Prime program. Note the final capacity and resistance readings. Take the battery with
To Next Page
Loading...
Need help?
General