MAINTENANCE PROCEDURES
tmo2016-010-048_a
TIGHTEN ING SEQ UENC E
NO TICE
Always use the recom-
mended wheel nuts for the type of
wheel. Using a different nut could
cause damages to the rim or studs.
Tire Pressure
WARNING
Tire pressure greatly affects vehi-
cle handling and stability. Insuf-
ficient pressure may cause tire to
deflate and rotate on wheel. Over-
pressure may burst the tire. Al-
ways follow recommended pres-
sure. NEVER set tire pressure be-
low minimum. It could cause the
tire to dislodge from the rim.
Check pressure w hen tires are cold
before us ing the vehicle. Tire pres -
sure changes with temperature and
altitude. Rechec k press ure i f one of
these conditions has c ha nged.
Refer to
SPECIFICATIONS
for proper
tire pressure.
NOTE: Although the tires are s pec if-
ically designe d for off-road use, a flat
may s til l occur. Therefore, it is recom -
mende d to carry a tire gauge, tire pu m p
and a repair kit.
Tire Inspe ct ion
Check tire for dam age and wear. Re-
place if necessary.
WARNING
Do not rotate tires. The front and
rear tires have a different size. The
left and right tires have different
unidirectional tread patterns.
Tire Replacement
Tires replac em ent should be per-
formed by an authorized Can-Am
dealer, a repair shop or person of your
choosing .
WARNING
– Replace tires only with the same
type and size as original tires.
– For unidirectional tread pat-
tern, ensure that the tires are
installed in the correct direction
of rotation.
– Tires should be replaced, by an
experienced person, in accor-
dance with tire industry stan-
dards and tools.
Suspension s
Front Suspension Lubrication
SUSPENSION GREASE
Scandinavia
SYNTHETIC
SUSPENSION
GREASE (EUR)
(P/N 779226)
All other
countries
SYNTHETIC
SUSPENSION
GREASE
(P/N 779163)
Lubricate front arms a nd stabilizer bar
bushings (if equipped).
There are tw o grease fittings on each
arm oriented upwards.
There is one grease fitting on each sta-
bilizer bar pivot bushing.
______________
143
To Next Page
Loading...
Need help?
General
