7.6" DIG ITAL DISPLAY
Icons and Indicators
ICONS AND INDICATORS
Denotes ECO m ode
is selected.
Denotes Work mode
is selected
When lit, seat belt
not buckled with
vehicle immobilized.
Flashing when vehicle
is moving.
When lit, indicates
that a maintenance
is required. See your
authorized Can-Am
dealer or per son of
your own choosing for
the maintenance.
Track kit active (If
equipped)
Se tti ngs
Setup
Using MENU button, select SET-
TINGS and hold to ente r setting menu.
OK button ca n be press ed ins te ad of
holding MENU button.
219002049-302
1. DR IVE MODE button
2. MENU button
3. O K button
4. TRIP button
Maintenance Reset
NOTE: Only when the main tena nc e
icon is disp lay ed.
Using MENU button, select RES
MAINT a nd ho ld to reset maintenance.
Fault Codes
NOTE: Only when fault codes are ac-
tives.
Using MENU button, select CODES
and hold to see active fault codes.
Fault codes will be scrolled on the
Lower Displ ay.
Reset Stats
Using MENU button, select RESET
STAT and hold to reset.
Unit Selection
This multifunction ga uge is factory pre-
set in Imperial units but it is possible to
change it to Metric units.
Using MENU button, select UNITS
and hold button to change units.
Speed/RPM
The speed and RPM display c a n be
swapped.
Using MENU button, select
SPEED/RPM and hold button to
invert speed and R PM display.
Setting Clock
Using MENU button, S elect CLOCK
and hold to change time.
1. Press MENU button to select clock
display.
2.PushandholdMENUbuttonfor1
second.
3. Press MENU button to select 12: 00
AM PM or 24:00 tim e ba s e.
4. Push and hold MENU button or OK
button to acknowledge selection.
5. Press MENU button to change
hours (hours flash).
_______________
83
To Next Page
Loading...
Need help?
General
