MESSAGES IN MULTIFUNCTION GAUGE
If a n abnormal engi ne con dition occurs , the foll owing message s can be combin ed
with a pilot lamp.
MESSAGE DESCRIPTION
D.E.S.S. KEY NOT
RECOGNIZED
Optional D.E.S.S. key installed: D.E.S.S. key requi res cleaning.
BAD KEY
Optional D.E.S.S. key installed:Wrong key used in the ignition
switch. Use the right key for the vehi cle.
CHECK ENGINE
All active or previously activated faults that require at tention.
No engine limitation engaged.
LIMP HOME
Critical faults requiring diagnostic as soon as possible.
An engine limitation is engaged and/or the engine behavior is
modified.
ECM CRC ERROR
Error message from ECM.
TPS FAULT Throttl e body fault , generally followed by a Limp Home message.
BRAKE SWITCH
FAULT
Brake signal fault.
ECM NOT
RECOGNIZED
Message displayed when the gauge is unable to identify the
ECM.
CHECK DPS
(models with DPS)
Check engine pilot light on. Indicates that the DPS (Dynamic
Power Steering) does not work properly. See an authori zed
Can-Am dealer.
PPS FAULT
Faulty Pedal Position Sensor(s) (PPS). Refer to
OVERRIDE
SWITCH
in
SECONDARY CONTROLS
to drive the vehicle in the
limp home m ode.
MANUAL LIMP
HOME
Confirm s the Manual Limp Home is engaged using the Override
Switch in case of a PPS fault.
FUEL SENDER
RANGE
PERFORMANCE
When t he fuel sender r esistor value i s out of range the
multifunction gauge (analog/digital) will detect it and display the
message.
172
______________
To Next Page
Loading...
Need help?
General
