MAINTENANCE PROCEDURES
Unplug c onnector from bulb .
tmo2016-010-041_a
TYP ICAL
Rotate bulb.
tmo2016-010-042_a
TYP ICAL
Pull out bulb.
Properly reinstall rem ov ed parts i n the
reverse order of their removal.
Va lid ate headlights operation.
Headlight Beam Aiming
Turn adjustment screw to adjust beam
height to your convenience .
NOTE: Adjust headlig hts evenl y.
tmo2016-010-151_a
1. Adjustment screw
Taillight Bulbs Replacement
The taillights are built wi th LEDs (light
emitting diode) a nd this t ec hnology
proved to be rel iable. In the unlikely
event they do not work, have them
checked by an authorized Can-A m
dealer, a repair shop or person of your
choosing .
Drive S haft Bello w s a nd
Protector
Drive Shaft Bellows and Protector
Inspection
Visually inspect drive shaft protectors
and bellow s condition.
Check protectors for da m a ge or rub-
bing a gainst shafts.
Check be llows for cracks, tears, le ak-
ing grease, etc.
Repair or replace damaged parts a s
necessary.
tmo2016-010-153_a
FRONT OF VEHICLE
1. Inner drive shaft bellows
______________
141
To Next Page
Loading...
Need help?
General
