■ SERIAL
COPIER (Service mode for printer) > OPTION (Specification setting mode) > SERIAL
SN-MAIN Write serial number
Detail To write the serial number of this machine in the Main Controller PCB.
When executed, the half-size alphanumeric characters entered in [Location] of [Menu] are written
in the Main Controller PCB.
When replacing the Main Controller PCB, be sure to write the serial number in the new PBC to
prepare for trouble since the serial number of the device is not succeeded.
Use Case
When replacing the Main Controller PCB.
Adj/Set/Operate Method
1) Write down and keep the current data in [Location].
2) Turn OFF and then ON the main power.
3) Replace the Main Controller PCB.
4) Turn ON the main power.
5) Enter the serial number of this machine in [Location].
6) Execute this item.
7) Turn OFF and then ON the main power.
Once the serial number has been written in the Main Controller PCB, the data of [Location] will be
deleted.
8) Output the spec report by SPEC, and check that the entered serial number is registered.
9) Enter the data backed up in step 1 in [Location].
Caution
Since the above "Location" is only temporarily used to store data. Therefore back up the data
before input and enter it again after writing is completed.
Related Service Mode
COPIER > FUNCTION > MISC-P > OUTPUT > SPEC
Additional Functions
Mode
RUI: Settings/Registration Menu: System Management Settings > Device Information Settings >
Location
LUI: Menu > System Manager Settings> Device Information Settings > Location
■ FNC-SW
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
CRG-PROC Set oprtn at toner ctrdg estd life reach
Detail To set the operation of the machine when the parts counter of the toner cartridge reaches the
estimated life value.
Adj/Set/Operate Method
Enter the setting value, and then press OK or Apply key.
Display/Adj/Set Range
0 to 2
0: Do not stop
1: Stop once
2: Stop completely
Default Value
0
DRUM-PROC Set oprtn at drum ctrdge estd life reach
Detail To set the operation of the machine when the parts counter of the drum cartridge reaches the
estimated life value.
Adj/Set/Operate Method
Enter the setting value, and then press OK or Apply key.
Display/Adj/Set Range
0 to 2
0: Do not stop
1: Stop once
2: Stop completely
Default Value
0
8. Service Mode
260
To Next Page
Loading...
