Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
None The next line is printed immediately after a line is printed.
1 sec. / 3 sec. / 5 sec. / 7 sec. / 9 sec. The next line is printed when the set time elapses after a line is printed.
* Increase the time according to the occurrence condition of bleeding or unevenness.
E Roll Paper Margin for Safety
You can specify the length of a margin on the leading edge of paper to ensure that paper susceptible to curling is held
firmly against the Platen.
•
F Near End Margin
Specify the length of the Near End Margin (the leading edge margin) of the roll, as needed.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
3 mm (0.12 in) The document is printed in the standard size.
* Select this when you do not have any problems in printing.
20 mm (0.8 in) Select this when rubbing against the printhead occurs such as when using paper that tends to
curl.
G
Cut Speed
Select the speed of automatic cutting, as needed. You can adjust this setting if paper is not cut well when automatic
cutting is used.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
High Speed When the Standard setting does not result in a clean cut surface, select this.
Standard Select this when you do not have any problems in automatic cutting.
Low Speed This helps prevent adhesive from sticking to the cutter and keeps the cutter sharp if you select it
when using adhesive paper.
H Automatic Cutting
Set whether to perform roll cutting automatically or print a cut line.
The following settings are available for automatic cutting.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
None After printing completes, the roll is not cut per page, and the next page of data is printed succes-
sively.
Print Cut Guideline After printing completes, a line is printed per page, and the next page of data is printed succes-
sively.
I Calibration Value
You can specify whether to apply the results of calibration performed on the printer to image processing.
Setting Item Details
Printer Default The setting of the control panel of the printer is applied.
Enabled Print using the calibration results.
Disabled Print without using the calibration results. Select this to avoid the changing of the color of images
during printing by color calibration.
iPF6400
Paper Detailed Settings Dialog Box (Mac OS X)
User's Guide
Mac OS X Software Printer Driver
371
To Next Page
Loading...
Need help?
General
