The printer stops during a print job
The printer stops during a print job
An error message is shown on the Display Screen ............................................................................................... 890
The printer ejects blank, unprinted paper .................................................................................................................. 890
An error message is shown on the Display Screen
An error message is shown on the Display Screen
Cause Corrective Action
An error message is displayed during printing. Check the error message and take action as necessary.
(See "Error Messages.") →P.912
The last portion of roll paper was used during a print job, and paper could not be
advanced because the trailing edge is taped to the roll.
Remove the used roll and insert a new roll.
(See "Removing the Roll from the Printer.") →P.538
(See "Removing Rolls From the Roll Holder.") →P.540
(See "Loading and Printing on Rolls.") →P.23
The printer ejects blank, unprinted paper
The printer ejects blank, unprinted paper
Cause Corrective Action
The leading edge of the roll paper was cut
to straighten it.
The leading edge of rolls may be cut to straighten it if Trim Edge First is set to a value other than
Off in the Control Panel menu.
(See "Cutting the Leading Edge of Roll Paper Automatically.") →P.548
The Printhead nozzles are clogged. Print a test pattern to check the nozzles and make sure the Printhead is in good condition for print-
ing.
(See "Checking for Nozzle Clogging.") →P.845
A print job was received from an incom-
patible printer driver.
Use the correct imagePROGRAF printer driver for the printer and try printing again.
The printer is damaged. Contact your Canon dealer for assistance.
An error message is shown on the Display Screen
iPF6400
User's Guide
Troubleshooting The printer stops during a print job
890
To Next Page
Loading...
Need help?
General
