2
Hold down the Power button for more than a second.
After "Shut Down.. Please Wait.." is shown on the Display
Screen, the printer shuts off.
Loading and Printing on Rolls
Loading and Printing on Rolls
These are the basic steps for loading and printing on rolls.
Follow these steps to load and print on rolls.
•
If you use the optional Stand, you can store printed documents in the Output Stacker. see "Using the Output Stack-
er." →P.564
•
You also can install and use the printer on a table, etc., instead of using the Stand.
Important
• Keeping a roll in the printer for a long time without printing on it may leave a depression on the leading edge.
When printing quality is most important, we recommend setting TrimEdge Reload to On or Automatic so that the pa-
per edge is automatically cut before printing.
• Before printing banners or other long documents, tap the Output Stacker. We recommend that you spread a clean cloth
or paper on the floor and select Eject as the cutting method for rolls to prevent the printed surface from becoming dirty
or scratched. (See "Specifying the Cutting Method for Rolls.") →P.544
Note
• For details on supported sizes and types of rolls, see Paper Sizes or the Paper Reference Guide. (See "Paper Sizes.")
→P.524 (See "Types of Paper.") →P.524
• To wait until the ink dries after printing before cutting the roll, set Drying Time in the printer driver. (See "Specifying the
Ink Drying Time for Rolls.") →P.542
• Once you have used all the paper on a roll, clean the platen. If the Platen inside the Top Cover becomes dirty, it may soil
the underside of paper. (See "Cleaning Inside the Top Cover.") →P.861
1
Turn the printer on. (See "Turning the Printer On and Off.")
→P.21
iPF6400
Loading and Printing on Rolls
User's Guide
Basic Printing Workflow Printing procedure
23
To Next Page
Loading...
Need help?
General
