Cause Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause, the type of paper loaded does not match
the type specified in the printer driver.
2.
Replace the loaded paper with paper of the type and size you have specified in
the printer driver.
(See "Loading and Printing on Rolls.") →P.23
(See "Loading and Printing on Sheets.") →P.26
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
When Detect Mismatch in the Control Panel menu is
set to Warning, the type of paper loaded does not
match the type specified in the printer driver.
You can continue to print, but note that this error may cause problems in the printing
results.
The paper is too small.
The paper is too small.
Cause Corrective Action
When Detect Mismatch in the Control Panel menu
is set to Pause, paper smaller than the size specified
in the printer driver is loaded.
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
Adjust the paper size setting in the printer driver to match the size loaded in the printer
as follows.
1.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2.
Change the paper size setting in the printer driver to the size loaded in the printer
and try printing again.
Replace the loaded paper with paper of a size that matches the size setting in the print-
er driver as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button to stop print-
ing.
2.
Replace the loaded paper to match the settings in the printer driver and try printing
again.
(See "Loading and Printing on Rolls.") →P.23
(See "Loading and Printing on Sheets.") →P.26
When Detect Mismatch in the Control Panel menu
is set to Warning, paper smaller than the size speci-
fied in the printer driver is loaded.
You can continue to print, but note that this error may cause problems in the printing
results.
The paper is too small.
The paper is too small.
Cause Corrective Action
A sheet has come out of the printer during printing.
1.
Press the OK button and remove the sheet.
2.
Confirm the paper size and setting.
3.
Reload the paper.
(See "Loading Sheets in the Feed Slot.") →P.554
The loaded paper is too small.
(When you have attempted to print a test print sheet or other print-
er status information.)
Replace the roll with a roll 10 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") →P.538
(See "Removing Rolls From the Roll Holder.") →P.540
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Loading Rolls on the Roll Holder.") →P.531
(See "Loading Rolls in the Printer.") →P.534
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
iPF6400
The paper is too small.
User's Guide
Error Message Messages regarding paper
915
To Next Page
Loading...
Need help?
General
