Setting Item Description, Instructions
Adjust
Printer
Head
Posi.
Adj.
Other
Manual Input the setting values from the adjustment pattern printing re-
sults and adjust the printing position to fix misaligned printing.
Normally, select Standard. However, when printing on special
paper, or if printing is not improved after Standard, try Manual.
(See "Manual Adjustment to Straighten Lines and Colors.")
→P.732
Feed Pri-
ority
Adj. Pri-
ority
Automatic Specify exact paper feeding, if desired. Normally, select Auto-
matic. Choose Print Quality for attractive printing. Choosing
Print Quality also makes banding less noticeable. Choose
Print Length if you prefer to feed the paper an exact amount.
However, note that slight banding may occur in the direction of
carriage scanning when Print Length is selected.
Print Quality
Print Length
Adj.
Quality
Auto(GenuinePpr) Specify this mode with paper identified in the Paper Reference
Guide.(See Paper Reference Guide.)
The printer prints and reads a test pattern for automatic adjust-
ment of the feed amount. (See "Automatic Banding Adjust-
ment.") →P.738
Auto(OtherPaper) Specify this mode with paper not in the Paper Reference
Guide.(See Paper Reference Guide.)
The printer prints and reads a test pattern for automatic adjust-
ment of the feed amount. Note that this function takes more
time and consumes more ink than Auto(GenuinePpr). (See
"Automatic Banding Adjustment.") →P.738
Manual Use this mode with highly transparent media or other paper for
which Auto(GenuinePpr) or Auto(OtherPaper) cannot be
used.
Print a test pattern for adjustment of the feed amount based on
the type of paper. (See "Manual Banding Adjustment.")
→P.739
Adjust
Length
Adjust-
ment-
Print
A:High Print a test pattern for particular types of paper to compensate
for paper stretching or shrinkage, after which you enter the
amount of adjustment. (See "Adjusting Line Length.")
→P.742
B:Standard/Draft
Change
Settings
A:High Displayed when you have selected Feed Priority > Adj. Prior-
ity > Print Length.
Adjustment relative to the amount of stretching or shrinkage of
the current paper.
Enter either the adjustment results from AdjustmentPrint or
the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends to
shrink, decrease the feed amount by choosing a lower adjust-
ment value. (See "Adjusting Line Length.") →P.742
B:Standard/Draft
Adj Far Ed Feed Choose Yes to adjust the feed amount for the trailing edge.
Calibra-
tion
Auto Adjust Execute color calibration.
A test pattern for color calibration is printed and the adjustment
values are set automatically.
(See "Color Calibration Using the Printer Sensor.") →P.758
Calibration Log The Date, Paper Type, and Adjustment Type for which color
calibration was executed are displayed on the Display Screen
where you can confirm them.
Common calibration and unique calibration are the Adjust-
ment Type of color calibration.
Menu Settings
iPF6400
User's Guide
Control Panel Printer Menu
652
To Next Page
Loading...
Need help?
General
