Canon imagePROGRAF iPF6400 User Manual

5
Select the IPv4 tab. In IP Address, enter the IP ad-
dress assigned to the printer, and then enter the subnet
mask in Subnet Mask and the default gateway in
Gateway Address.
Important
• You must specify the IP address here to be able to configure NetWare protocol settings using RemoteUI.
6 Click Set.
7 Click OK after the Confirmation message is displayed.
8 Exit imagePROGRAF Device Setup Utility.
Specifying the frame type using the printer Control Panel
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Settings/Adj. tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2 Press the OK button.
The Set./Adj. Menu is displayed.
Specifying the Printer's Frame Type iPF6400
User's Guide
Network Setting NetWare Settings
688

Canon imagePROGRAF iPF6400 Specifications

General

Color	Yes
Printing colors	Black, Blue, Cyan, Green, Grey, Magenta, Matte black, Photo cyan, Photo grey, Photo magenta, Red, Yellow
Maximum resolution	2400 x 1200 DPI
Page description languages	GARO
Maximum print size	-
Maximum roll length	18 m
ISO A-series sizes (A0...A9)	A1, A2
ISO B-series sizes (B0...B9)	B2
Internal memory	384 MB
Sound pressure level (printing)	47 dB
Power supply	100 W
Power consumption (off)	5 W
Power consumption (standby)	6 W
Storage temperature (T-T)	15 - 30 °C
Operating relative humidity (H-H)	10 - 80 %
USB port	No
USB 2.0 ports quantity	0