Chapter 1
1-150
4. Conductivity of Ink
The ink used in this printer is electrically conductive. If ink leaks to into the mechanical unit, wipe clean with a soft, well-wrung damp cloth. If ink leaks onto
electrical units, wipe them completely using tissue paper. If you cannot remove ink completely, replace the electrical units with new ones.
If electrical units are powered with ink leaked onto them, the units may damage.
Never connect the power cord when ink has leaded onto the electrical units.
1.7.2.3 Ink Tank
0013-1924
iPF6100 / iPF6200 / iPF6000S / iPF6300 / iPF6350 / iPF6300S
1. Unpacking the Ink Tank
Do not unpack the ink tank until you are ready to install it.
When installing the ink tank, be sure to shake it slowly 7 to 8 times before unpacking it. Otherwise, the ink ingredients may precipitate and degrade the print quality.
To prevent foreign matter from entering the ink port, install the unpacked ink tank in the printer immediately.
2. Handling the Ink Tank
To prevent foreign matter from entering the ink flow path and causing ink suction and printing problems, never touch the ink port and contacts of the ink tank.
When you press down the ink tank lock lever, the needle enters the ink port, allowing ink to flow between the printer and ink tank.
Do not raise or lower the ink tank lock lever except when replacing the ink tank.
F-1-61
[1] Ink tank
[2] Ink tank lock lever
[3] Contacts
[4] Ink port
1.7.2.4 Handling the Printer
0016-8169
iPF6100 / iPF6200 / iPF6000S
[4]
[3]
[1]
[2]
To Next Page
Loading...
