Canon iPF6100 - Cutter

Chapter 4
4-18
4.3.6 Cutter
0016-8468
iPF6100 / iPF6200 / iPF6000S
a) Removing the Cutter
1) Perform service mode: [SERVICE MODE] > [REPLACE] > [CUTTER] and then choose [YES] to move the cutter to the replacement place.
2) Remove two screws [1] to remove the cutter [2].
F-4-35
MEMO:
After replacing the cutter, obey the message that displayed on the LCD to initialize the parts counter information. Then, the cutter moves to home position auto-
matically.
[2]
[1]