Chapter 4
4-93
8) Retighten the two screws [1] loosened in Step 2) to secure the wire guide.
F-4-193
9) Pass the ink tubes through the wire guides.
4.5.5 Procedure after Replacing the Head Management Sensor
0012-6487
iPF6100 / iPF6200 / iPF6000S / iPF6300 / iPF6350 / iPF6300S
Since the distance between the head management sensor and the carriage unit varies among printers, the optical axis is factory-adjusted to adjust the non-discharging
detection position. When you have replaced the head management sensor or performed assembly/reassembly of surrounding parts that can change the distance be-
tween the head management sensor and the carriage unit, reasjustment is required
Peform the readjustment in the service mode.
Service mode : SERVICE MODE > ADJUST > NOZZLE CHK POS.
[1]
To Next Page
Loading...
