Canon iPF6100 - Page 373

Chapter 4
4-65
b) Removing the main controller mounting plate
1) Remove the main controller PCB.
2) Free the harness from the harness guide.
3) Remove the screw [1] and remove the flexible guide [2].
F-4-144
4) Remove the four screws [1] and two hooks [2] from the harness guide and remove the main controller mounting plate [3].
F-4-145
c) Note on installing the cable holder
In installing the cable holder, secure ferrite core [1] to the flexible cable on the carriage with the cable holder before hooking the flexible cable from the operation
panel at the three claws [2].
F-4-146
[1]
[2]
[1]
[1]
[2]
[3]
[2][1]