Chapter 6
6-16
T-6-9
T-6-10
T-6-11
T-6-12
9 ROLL_STB OUT Roll motor driver strobe signal
10 ROLL_DAT OUT Roll motor driver data signal
11 ROLL_CLK OUT Roll motor driver clock signal
12 GND - GND
13 GND - GND
J2801 (Feed motor)
Pin Number Signal name IN/OUT Function
1 LF_OUTB OUT Feed motor drive signal B
2 LF_OUTA OUT Feed motor drive signal A
J3011 (Purge motor, Pump encoder sensor, Pump cam sensor, Lift motor, Head management sensor)
Pin Number Signal name IN/OUT Function
1 LIFTOUTCOM OUT Lift motor power supply
2 LIFT_OUTAP OUT Lift motor drive signal AP
3 LIFT_OUTAM OUT Lift motor drive signal AM
4 LIFT_OUTBP OUT Lift motor drive signal BP
5 LIFT_OUTBM OUT Lift motor drive signal BM
6 GND - GND
7 FUTO_CLMP OUT Head management sensor unit clamp signal
8 FUTO_XLEDON OUT Head management sensor unit LED ON/OFF signal
9 SNS_5V Power supply (+5V)
10 FUTO_XCMP0 IN Head management sensor unit skew detection signal
11 PUMP_OUTB OUT Purge motor drive signal B
12 PUMP_OUTA OUT Purge motor drive signal A
13 GND - GND
14 PUMP_ENCA IN Pump encoder sensor output signal A
15 SNS_5V Power supply (+5V)
16 PUMP_ENCB IN Pump encoder sensor output signal B
17 PUMP_CAM_3V OUT Power supply (+3.3V)
18 GND - GND
19 PUMP_CAM_SNS IN Pump cam sensor output signal
J3101 (Carriage motor)
Pin Number Signal name IN/OUT Function
1 CR_HWP IN Carriage motor hole device W-phase + signal
2 CR_HWM IN Carriage motor hole device W-phase - signal
3 CR_W OUT Carriage motor W-phase drive signal
4 CR_HVM IN Carriage motor hole device V-phase - signal
5 CR_U OUT Carriage motor U-phase drive signal
6 GND - GND
7 CR_V OUT Carriage motor V-phase drive signal
8 SNS_5V Power supply (+5V)
9 N.C. - N.C
10 CR_HVP IN Carriage motor hole device V-phase + signal
11 CR_HUM IN Carriage motor hole device U-phase - signal
12 CR_HUP IN Carriage motor hole device U-phase + signal
J3202 (Ink tank ROM PCB, Ink detection sensor)
Pin Number Signal name IN/OUT Function
1 TANK_DAT0 IN/OUT Ink tank data signal 0
2 TANK_DAT1 IN/OUT Ink tank data signal 1
3 TANK_3V OUT Power supply (+3.3V)
4 TANK_DAT2 IN/OUT Ink tank data signal 2
J2703 (Auto feed roll unit)
Pin Number Signal name IN/OUT Function
To Next Page
Loading...
