Canon iPF6100 - Page 635

Chapter 7
7-125
T-7-200
Print item Print content Printed value
PARTS CNT. [Value of each
parts counter]
Status OK/W1/W2/E
Number of days after set Unit: Days
Count
Life threshold
Usage Unit: %
Cumulative count
COGFF CONDITION Cogging FF result 0: Disabled
1: Enabled
2: Check required
3: Adjust reruired
PARAM0-F Parameters 1 REF: Motor error (6 digits)
PHASE: Phase (3 digits)
AMP: Amplitude (3 digits)
RATE: Decay rate (3 digits)
PARAM0-B Parameters 2 REF: Motor error (6 digits)
PHASE: Phase (3 digits)
AMP: Amplitude (3 digits)
RATE: Decay rate (3 digits)
LF SCALE
adjustment value (user
value)
LF-A LF8 pass
LF-B LF1 pass
SCALE-A Scale clean
SCALE-B Scale fast
PV AUTO JUDGE Ink reduction mode ON (NORMAL/LOW only when ON)/Number of times
OFF is entered