Canon iPF6100 - Page 665

Chapter 8
8-17
Ink tank:BK error
Press OK and
replace ink tank.
03830304-256C G ink tank EEPROM error Renew the G ink tank
Top cover is open.
Turn off printer,
wait a while, and
turn it on again.
03031000-2E0F Top cover abnormally open Close the top cover and turn on the printer again.
Ink tank cover
is open.
Turn off printer,
wait a while, and
turn it on again.
03031000-2E10 Ink tank cover abnormally open Close the ink tank cover and turn on the printer again.
Maintenance
cartridge full.
Replace
the maintenance
cartridge.
03841001-2819 Maintenance cartridge full Renew the maintenance cartridge.
No Maintenance
Cartridge capacity.
Replace
the maintenance
cartridge.
03841001-281B Not enough space in the maintenance
cartridge prior to cleaning
Replace the maintenance cartridge.
No maintenance
cartridge.
Check
the maintenance
cartridge.
03841101-2818 Maintenance cartridge not available Set a maintenance cartridge.
Insert the maintenance cartridge fully into position.
Maintenance
cartridge problem.
Replace
the maintenance
cartridge.
03841201-2816 Maintenance cartridge EEPROM error Renew the maintenance cartridge.
Maintenance
cartridge problem.
Replace
the maintenance
cartridge.
03841201-2817 Maintenance cartridge ID error Renew the maintenance cartridge.
Roll printing is
selected, but sheets
are loaded.
Press OK,
remove the sheets,
and load a roll.
03860002-2E0A Data with a roll media specification has
been received when a sheet tray is
loaded.
Reload the cut sheets.
Borderless printng
not possible. Check
roll width and
spacers.
Online: Print
Load/Eject:
Change Paper
03861001-2405 Paper loaded at a position inaccessible
for borderless printing
Check to see if a borderless printing spacer is installed.
Reload the paper.
Borderless printng
not possible. Check
paper size setting.
Online: Print
Load/Eject:
Change Paper
03861001-2406 Data unfit for borderless printing Check the paper size.
Change the paper size.
Insufficient paper
for job
Online: Print
Stop: Stop Printing
Load/Eject:
Change Paper
03862000-2E09 Not enough roll media on remaining roll
media quantity detection
Renew the supply of roll media.
Wrong paper size.
Check paper size
setting on computer.
Online: Print
Stop: Stop Printing
03063000-2E08 Mismatch between data width and paper
width
Verify the paper size setting.
Cannot cut paper.
Press Load/Eject
and reload the
paper.
03870001-2015 Cutting failure Cut paper manually.
Check the cutter.
Display massage Code* Condition detected Action