Canon LBP710Cx - Page 544

Sensor error. Cannot detect paper type.
The sensor for automatic paper type detection is broken.
● Contact your local authorized Canon dealer or the Canon help line.
● To continue the printing, set <Auto Detect Ppr Type> to <Do Not Use> and set the paper type for the
paper source to match the type of the actually loaded paper. Auto Detect Ppr Type(P. 504)
Set below paper.
Paper of the size specied to print is not loaded or the selected paper source does not match the paper
size.
● Load the paper of the size specied to print in the selected paper source.
Loading Paper(P. 38)
● Select the paper source loaded with the paper of the size specied to print.
Paper Source(P. 500)
● To forcibly print on the loaded paper, press ( ). For the multi-purpose tray, the setting
specied for <MP Tray Paper Size> is automatically changed to the paper size of the print data.
Starting up... 80 Initializing MEAP. Do not turn power OFF.
You have tried to shut down the machine while MEAP was being initialized.
● When the MEAP initialization is complete, this message is automatically removed. Wait until the message
is removed.
Starting up... 80 Preparing MEAP... Do not turn power OFF.
You have tried to shut down the machine while MEAP was preparing for operation.
● When MEAP is ready for operation, this message is automatically removed. Wait until the message is
removed.
Syntax error.
Invalid data has been sent during printing with the UFR II printer driver.
● Change the printer driver settings or the format of print data, and print the le again.
● When you press ( ), the print job is canceled.
Turn OFF main power. Check options.
The optional paper feeder is not properly installed.
● Shut down the machine, properly install the optional paper feeder, and then turn ON the power.
Turning ON/OFF the Power(P. 34)
Troubleshooting
538