<Connect. Info.>
You can view the information on the Direct Connection being proceeding.
<Disconnect>
Stops the Direct Connection procedure. When printing, scanning, or other
desired operation is complete, tap this button to terminate the connection.
● When the machine is in Direct Connection mode, it is possible that you cannot connect to the Internet
depending on your mobile device.
● Direct Connection is only possible as a one-to-one connection between the machine and a single mobile
device. You cannot connect 2 or more mobile devices to the machine at a time.
● If wireless connection from the mobile device is not performed within 5 minutes while the SSID and network
key are displayed, the connection waiting state terminates.
● If while in communication by Direct Connection, a duration when there is no data transmission between the
machine and the mobile device lasts for some time, the communication may terminate.
● The machine's SSID and network key are changed each time the Direct Connection procedure is started.
● While in Direct Connection, sleep mode is not as effective at saving power.
● When both <Enable Direct Connection> and <Enable NFC> are set to <On>, sleep mode is not as effective at
saving power even if not in Direct Connection.
Enable Direct Connection(P. 632)
Enable NFC(P. 708)
● If you use the Direct Connection, do not set the IP address manually on the mobile device. Doing so may
prevent proper communication after using the Direct Connection.
Using NFC together with Access Point Mode (MF416dw)
● You can use NFC and Access Point Mode in combination. By simply touching your mobile device to the NFC
mark on the operation panel of the machine, you can read out the machine's SSID and network key
automatically. Connecting by a Touch on the Machine (NFC) (MF416dw)(P. 390)
Can Be Used Conveniently with a Mobile Device
389
To Next Page
Loading...
Need help?
General
