Platen Glass
0UWX-0CK
Regularly wipe off the dust from the platen glass and the underside of the feeder to prevent smudges to be printed on
documents or printouts.
1
Turn OFF the machine, and unplug the power cord from the AC power outlet.
● When you turn OFF the machine, data that is waiting to be printed is deleted. Fax documents that were
received by using the Memory Reception function, faxes that are waiting to be sent, and reports that are
automatically printed after sending and receiving faxes are not deleted.
2
Open the feeder.
3
Clean the platen glass and the underside of the feeder.
● Clean the areas with a cloth dampened with water. Then, wipe the area with a soft, dry cloth.
● In addition to the platen glass and underside of the feeder, make sure to clean and wipe the white strip of
plate ( ) and the surface of the transparent plastic part ( ), too.
● When wiping the transparent plastic part ( ), take care not to bend the plastic.
If the problem persists
Remove the transparent plastic part ( ) and wipe it.
1
Hold the tabs ( ) at both ends of the transparent plastic part, and remove the plastic part by gently
lifting the rearward end rst.
Maintenance
787
To Next Page
Loading...
