step Action additional Info
9
NOTE
If your system does NOT have
a READER attached you might
get an error message in the
feedback screen. You can ig-
nore the message. The instal-
lation will continue without
any problems.
Reboot to start installation
Press 'OK' to reboot the printer and to
continue with the upgrade.
After pressing 'OK' the printer will re-
boot and start installing firmware pack-
ages.
10
Switch off and on the printer
When the process is completed a screen
is displayed prompting you to switch the
printer off and on again.
Take the following steps:
1.
Restart the printer
Switch off the printer with the
power switch
Switch off all accessories (finish-
ing, paper-decks etc.)
Switch on all accessories
Switch on the printer with the
power switch
2. Select [OK]
11
Leave firmware upgrade mode
Press [Close] to leave the firmware Up-
grade mode.
12
Remove USB key with Printer firmware
The duration of the printer upgrade procedure
depends on the configuration that is installed.
Example: Main Engine, POD Deck, Finisher
AJ2 and 3 knife trimmer will take approx. 45
minutes.
If a HCS-F1/G1 is connected the additional
time will be approx. 30 minutes.
Check the versions
Firmware upgrade of Engine and Accessories (safe download mode)
90 Chapter 8 - Firmware upgrades via PRISMAsync
PRISMAsync V3.2
To Next Page
Loading...
Need help?
General
