154
• Time Zone
• Network Settings
When set to [Do not save], all the settings excluding camera’s date and time will be initialized.
Since the network settings will be initialized, connection to the camera will not be enabled. Use the Camera Management
Tool to configure the initial settings.
[Restore Default Settings]
After rebooting, follow the selection in [Network Settings and Management Information] to restore the default settings.
• It is recommended that the user back up each of the current settings before clicking [Exec] in [Restore Default Settings].
• The camera can also be restored to factory default settings using the reset switch. Note, however, that this will reset all camera settings
to factory default settings except for date and time (P. 181).
To Next Page
Loading...
