76
• Depending on the vibration of the camera, the image may appear stretched or distorted, which is a phenomenon caused by the
characteristics of the CMOS sensor and cannot be reduced by the image stabilizer function.
[Smart Shade Control Strength (Auto)]
Select the control strength when [Smart Shade Control] (P. 65) is set to [Auto].
• [Mild]: Select if noise is noticeable.
• [Medium]: Recommended setting for Auto mode (default setting)
• [Strong]: Select to increase visibility in dark areas.
[Haze Compensation Strength (Auto)]
Select the strength of compensation when [Haze Compensation] (P. 65) is set to [Auto].
• When [Haze Compensation] is set to [Auto] and [Haze Compensation Strength (Auto)] is set to [Strong], contrast may be strong between
bright and dark if the subject is not obscured by haze. If this happens, set [Haze Compensation Strength (Auto)] to [Mild].
[Motion-Adaptive Noise Reduction]
When [Enable] is selected, noise reduction is automatically adjusted according to movement. For scenes with little
movement, noise reduction is increased decreasing the data size.
[Pan/Tilt Speed Control]
Select the mode controlling the pan/tilt movement.
If [Control by zoom position] is selected, the pan/tilt speed will be slower in telephoto, and faster in wide-angle.
[AF Response]
Selects the responsiveness of the autofocus.
The setting values are High, Normal, and Low in order of the shortest time until the focus operation starts.
Day/Night
[Day/Night Mode Focus Control]
Select the focus control method for day/night mode switching. This is executed when [Focus] (P. 66) is set to [Manual].
• If a preset is set in [Event] > [Day/Night Mode Switching], this is executed when the [Focus] registered in the preset is set to [Manual].
[Compensation for fluorescent light source]
When switching the Day/Night mode, the focus position is corrected according to day mode or night mode under the
illumination environment of fluorescent light.
[One-shot AF]
One-shot AF is executed.
[Switching Brightness]
Select the brightness for switching Day/Night Mode when [Day/Night] (P. 65) is set to [Auto].
Select [Darker] if the video should be captured in color as much as possible.
Select [Brighter] to reduce noise. Note that this mode switches to monochrome sooner.
[Response (sec.)]
Select the number of seconds for determining when to switch Day/Night Mode, when [Day/Night] (P. 65) is set to [Auto].
Day/Night Mode switches when the brightness continues to exceed or fall below the brightness set in [Switching
Brightness] for the number of seconds selected.
• The intended effect may not be achievable, depending on the following conditions:
– the size of the subject
– the movement speed of the subject
– scenes with a lot of noise
– subjects without bright/dark contrast (white walls, etc.)
• When using [One-shot AF], since the camera focuses on the subject when switching day/night mode, it may not be able to focus on
the target subject if a person walks across the scene.
HM4x
HM4x
HM4x
To Next Page
Loading...
