Capstone Turbine Corporation • 16640 Stagg Street • Van Nuys • CA 91406 • USA
Installation Guide: Capstone C1000S/C800S/C600S with C1000 Series Controller
480064 Rev C (December 2018) Page 10 of 122
Capstone reserves the right to change or modify, without notice, the design, specifications, and/or contents of this document without
incurring any obligation either with respect to equipment previously sold or in the process of construction.
1.1.2. General Precautions
The following general precautions must be observed and followed at all times. Failure to do so
may result in personal injury and/or equipment damage.
Only Capstone Authorized Service Providers are permitted access to the inside of
the enclosure.
Do not start or operate the microturbine until after it has been properly
commissioned by Capstone Authorized Service Providers.
Read and understand the User's Manual before operating the equipment.
Read and obey all warnings and cautions.
Use appropriate personal protective equipment (PPE) when handling fuel or other
corrosive material.
Make sure all fuel connections are tight, free from leaks, and protected from damage.
Make sure all electrical connections are tight, clean, dry, and protected from weather and
damage.
The microturbine may be equipped with a heat recovery system. Use caution around relief
valves where hot water and steam may be present.
Use hearing protection when you work on or near an operating microturbine for extended
time periods.
Keep the equipment clean.
Keep all flammable materials away from the microturbine and its components.
Do not operate or work on the equipment if mentally or physically impaired, or after
consumption of alcohol or drugs.
Keep an ABC rated fire extinguisher near the microturbine.
Obey all applicable local, state, and national codes and regulations.
To Next Page
Loading...
Need help?
General