Capstone Turbine Corporation • 16640 Stagg Street • Van Nuys • CA 91406 • USA
Installation Guide: Capstone C1000S/C800S/C600S with C1000 Series Controller
480064 Rev C (December 2018) Page 44 of 122
Capstone reserves the right to change or modify, without notice, the design, specifications, and/or contents of this document without
incurring any obligation either with respect to equipment previously sold or in the process of construction.
Access between any loading area and the enclosure should be clear of obstruction and
allow for ease of movement for engines and components. Refer to C1000S Mechanical
Coordination Diagram (Table 1) for details.
Warranty and FPP policies for removal or replacement have been calculated based on
the service areas specified on the O&I drawings. When those areas are violated, the
customer, even under warranty, may be required to pay for the additional time required
to service the system.
Figure 18. C1000S/C800S/C600S Installation Clearances – Side View
To Next Page
Loading...
Need help?
General