OPERATING INSTRUCTIONS
106
LEFT PAGE
Bur 6-34090EUR
C. Place the transmission in the manual mode.
D. Shift the transmission into 2nd gear forward.
E. Release the parking brake.
F. Increase the engine speed to full throttle. the machine must not nove. If the
machine does move, decrease engine speed to low idle. See your Service
manual or your dealer for repairs.
G. Reset the parking brake.
10. Test the secondary steering at a maximum of 250 hour intervals. (See
Secondary Steering Check in Maintenance and Adjustments in this manual.)
Transmission Operation
The transmission in this machine has four (4) forward speeds and three reverse
speeds. Always select the correct speed for the job. If you have frequent stalls
(engine running at full throttle and the wheels not turning) select a lower gear.
The transmission can be operated in Automatic or manual mode.
Initial Machine Movement
1. Hold the foot brake on.
2. Cycle the transmission control lever through forward, reverse and neutral.
3. Release the parking brake by pressing the bottom of the parking brake switch.
4. Shift the transmission control lever into forward or reverse.
5. Release the foot brake.
6. Depress the foot throttle and the machine will move.
Manual Mode Operation
To put the transmission in the Manual mode press the bottom of the Autoshift
switch.
Up-Shifts Manual Mode
You can shift the transmission from a lower gear to a higher gear without reducing
the machine speed or engine speed. If the gear to be selected is two (2) or more
higher than the present gear, the transmission will automatically shift gears at 2.5
second intervals until the gear selected has been reached.
To Next Page
Loading...
