INSTRUMENTS/CONTROLS
67
RIGHT PAGE
Bur 6-34090EUR
TRANSMISSION DISPLAY CENTER
BD02B020
Maximum Gear Selection
The transmission can be programmed for the highest gear attainable in the
automatic mode or the manual mode. The operator can select 2nd, 3rd or 4th
gear. The gear that is chosen is the highest attainable gear that the transmission
will be able to reach. Machines shipped from the factory will have the minimum
gear set a 4.
Programming Maximum Gear Selection
● Press the program (C) switch.
● Press the up count (A) switch until the display reads 051.
● Return the program/reset (C, D) switch to the OFF (center) position.
● Read the number (2, 3, or 4) shown on the Display Center. If this is the gear
selection you want, press the program (C) or reset (D) switch.
● If you want a different maximum gear selection gear selection, press the up
count (A) switch until the number you want is displayed.
● Press the reset (D) switch momentarily (0.25 seconds).
A. UP COUNT C. PROGRAM
B. DOWN COUNT D. RESET
A
B
C
D
To Next Page
Loading...
