368
20-5 Performing a Data Transfer Operation
Connect the two units and then perform the following procedures.
Receiving unit
To set up the calculator to receive data, press 2 (RECV) while the data communi-
cation main menu is displayed.
2(RECV)
The calculator enters a data receive standby mode and waits for data to arrive.
Actual data receive starts as soon as data is sent from the sending unit.
Sending unit
To set up the calculator to send data, press 1 (TRAN) while the data communica-
tion main menu is displayed.
1 (TRAN)
Press the function key that corresponds to the type of data you want to send.
1 (SEL) ........ Selects data items and sends
2 (CRNT) .... Selects data items from among previously selected data items
and sends
6 (BACK) ..... All memory contents, including mode settings
uu
uu
uTo send selected data items
Press 1 (SEL) or 2 (CRNT) to display a data item selection screen.
1(SEL) or 2(CRNT)
Data items
123456
1 23456
To Next Page
Loading...
Need help?
General
