CHCNAV CHC i83 - Configuring a Base Receiver as a Wi-Fi NTRIP Caster for Use with a UAV; USV

CHC i83 User Manual 24
To set the broadcast FCC Call Sign, from the main menu (http://192.168.1.1), click on
Module Setting
then
Radio
Settings
:
If the
Radio Status
is
OFF
, click
ON
to turn on the radio power.
The
Call Sign Status
should be set to
ON
, the
Call Sign Interval
should be 15 minutes or less, the
Call Sign Message
should be your FCC Assigned Call Sign.
Once entered, click on
Save
to commit the changes to the internal radio.
Configuring a Base Receiver as a Wi-Fi NTRIP Caster for use with a
UAV / USV
The receiver has an internal NTRIP caster that can be used to send Base corrections to drone controllers or other
devices via Wi-Fi.
APIS or a Static IP enabled SIM card can also be used to transport corrections to external devices via the NTRIP protocol.
Once you configure the caster, it will stay setup until a complete factory reset is performed. This is a once and done
configuration.
1. Connect to the receiver via Wi-Fi as shown in ‘Connecting to a PC or Smartphone via Wi-Fi’ on page 18.