26
CP30 Mobile Computer
Reference Manual
1.7 CRADLE
A specified cradle is supported for CP30; it can transfer data or charging via a Micro USB
2.0 cable. There is also a LED indicator in front of the cradle to indicate the charging
status of battery. For plastic bolt switch that in front of the cradle information, please
refer to
Using Cradle.
Supports Micro USB 1.1 compatible.
Micro USB connections for Life Cycle 6000 Times (plug and unplug).
USB Synchronization between charging terminal and battery.
LED indicator to show battery charging status.
Supports 2 modes (ActiveSync On and Off) for charging and date transmission.
Charging Time shall be less than 4 hours. Typical is 3.5 hours.
DC Input 5V@2A, DC-Jack on the back of cradle.
100-240VAC 50/60Hz, 5VDC+5%2A with DC jack for AC adaptor.
Due to the limitation of CP30 terminal charging circuit, it supports 1000mA charging
current through ActiveSync disable or only under 500mA with ActiveSync enable.
Approx. 4 hours for spare battery via adaptor.
Approx. 4 hours for terminal via adaptor (ActiveSync is disabled)
Charging
Time
Approx. 8 hours for terminal via adaptor (ActiveSync is enabled)
To Next Page
Loading...
