CipherLab CP30 - Symbology Settings Table

152
CP30 Mobile Computer Reference Manual
Timeout between
same symbols
When in Continuous mode, set the minimum time that
must stop detect
before the scan engine decodes a second
same barcode. This reduces the risk of accidentally
scanning the same barcode twice.
 0.0~9.9 (second)
1.0 sec.
SYMBOLOGY SETTINGS TABLE
Laser Engine Description Default
Code 11 Enable
Check digit verification Decide whether to verify the check digit. If the check digit
is incorrect, the barcode will not be accepted.
 Disable
 One Check Digit
 Two Check Digits
No
Transmit Check Digit Decide whether to include the check digit in the data being
transmitted.
 "Check digit verification" must be enabled.
No
Select Length
 One or two fixed lengths
 Range (1~55)
4~55
Codabar Enable
CLSI editing When applied, the CLSI editing strips the start/stop
characters and inserts a space after the first, fifth, and
tenth characters of a 14-character Codabar barcode.
 The 14-character barcode length does not include
start/stop characters.
No
NOTIS editing Decide whether to include the start/stop characters in the
data being transmitted.
 NOTIS Editing is to strip the start/stop characters, i.e.
to disable "Transmit Start/Stop Characters".
No
Select Length
(min/max)
 One or two fixed lengths
 Range (1~55)
4~55
Code 128 Enable
GS1-128
(UCC/EAN-128)
Read GS1-128 barcodes with leading FNC1 character. Enable
ISBT 128 Read ISBT 128 barcodes. Enable
Industrial 25 (Discrete 25) Enable
Select Length
(min/max)
 One or two fixed lengths
 Range (1~55)
4~55