153
Appendix II Laser (SE955)
Interleaved 25 Enable
Convert to EAN-13 Convert a 14-character barcode into EAN-13 if the
following requirements are met:
The barcode must have a leading 0 and a valid EAN-13
check digit.
“Check digit verification” must be disabled.
No
Check digit verification Decide whether to verify the check digit. If desired, select
one of the algorithms below. If the check digit
is incorrect,
the barcode will not be accepted.
Disable
USS check digit
OPCC check digit
No
Transmit Check Digit Decide whether to include the check digit
in the data being
transmitted.
No
Select Length
(min/max)
One or two fixed lengths
Range (1~55)
4~55
Chinese 25 Enable
Code 39 Enable
Convert to Code 32 Convert to Italian Pharmacode. No
Code 32 Prefix Prefix character "A" to Code 32 barcodes. No
Check digit verification Decide whether to verify the check digit. If the check digit
is incorrect, the barcode will not be accepted.
No
Transmit Check Digit Decide whether to include the check digit
in the data being
transmitted.
" Check digit verification " must be enabled.
No
Code 39 Full ASCII Code 39 Full ASCII includes all the alphanumeric and
special characters.
No
Trioptic Code 39 Decide whether to decode Trioptic Code 39.
Trioptic Code 39 is a variant of Code 39 used in the
marking of computer tape cartridges. It always
contains six characters.
No
Select Length
(min/max)
One or two fixed lengths
Range (1~55)
4~55
Code 93 Enable
Select Length
(min/max)
One or two fixed lengths
Range (1~55)
4~55
MSI Enable
Check digit verification If Two Check Digits option is selected, an additional
verification is required to ensure integrity. Select one of
the algorithms below. If the check digit
is incorrect, the
barcode will not be accepted.
Single Modulo
10
To Next Page
Loading...
