Cisco 300 Series Administration Guide

Security: IPV6 First Hop Security
Configuring First Hop Security through Web GUI
434 Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
20
FHS Status
To display the global configuration for the FHS features:
STEP 1 Click Security > First Hop Security > FHS Status.
STEP 2 Select a port, LAG or VLAN for which the FHS state is reported.
STEP 3 The following fields are displayed for the selected interface:
• FHS Status
- FHS State on Current VLAN:—Is FHS enabled on the current VLAN.
- Packet Drop Logging:—Is this feature enabled for the current interface
(at the level of global configuration or in a policy attached to the
interface).
• RA Guard Status
- RA Guard State on Current VLAN:—Is RA Guard enabled on the current
VLAN.
- Device Role:—RA device role.
- Managed Configuration Flag:—Is verification of the managed
configuration flag enabled.
- Other Configuration Flag:—Is verification of the other configuration flag
enabled.
- RA Address List:—RA address list to be matched.
- RA Prefix List:—RA prefix list to be matched.
- Minimal Hop Limit:—Is minimum RA hop limit verification enabled.
- Maximal Hop Limit:—Is maximum RA hop limit verification enabled.
- Minimal Router Preference:—Is minimum router preference verification
enabled.
- Maximal Router Preference:—Is maximum router preference
verification enabled.
• ND Inspection Status
- ND Inspection State on Current VLAN:—Is ND Inspection enabled on
the current VLAN.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48