Cisco Catalyst 2960-XR User Manual

SUMMARY STEPS
1.
configure terminal
2.
hostname hostname
3.
ip domain-name domain-name
4.
crypto key generate rsa
5.
crypto ca trustpoint name
6.
enrollment url url
7.
enrollment http-proxy host-name port-number
8.
crl query url
9.
primary name
10.
exit
11.
crypto ca authentication name
12.
crypto ca enroll name
13.
end
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies the hostname of the switch (required only if you have
not previously configured a hostname). The hostname is required
for security keys and certificates.
hostname hostname
Example:
Switch(config)# hostname your_hostname
Step 2
Specifies the IP domain name of the switch (required only if you
have not previously configured an IP domain name). The domain
name is required for security keys and certificates.
ip domain-name domain-name
Example:
Switch(config)# ip domain-name your_domain
Step 3
(Optional) Generates an RSA key pair. RSA key pairs are required
before you can obtain a certificate for the switch. RSA key pairs
crypto key generate rsa
Example:
Switch(config)# crypto key generate rsa
Step 4
are generated automatically. You can use this command to
regenerate the keys, if needed.
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29434-01 97
Configuring Secure Socket Layer HTTP
Configuring a CA Trustpoint

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C