Cisco Catalyst 2960-XR User Manual

Table 23: Authentication Manager Commands and Earlier 802.1x Commands
DescriptionThe equivalent 802.1x
commands in Cisco IOS
Release 12.2(46)SE and earlier
The authentication manager
commands in Cisco IOS
Release 12.2(50)SE or later
Enable 802.1x authentication with the
wake-on-LAN (WoL) feature, and configure
the port control as unidirectional or
bidirectional.
dot1x control-direction
{both | in}
authentication
control-direction {both | in}
Enable the restricted VLAN on a port.
Enable the
inaccessible-authentication-bypass feature.
Specify an active VLAN as an 802.1x guest
VLAN.
dot1x auth-fail vlan
dot1x critical (interface
configuration)
dot1x guest-vlan6
authentication event
Configure a port to use web authentication
as a fallback method for clients that do not
support 802.1x authentication.
dot1x fallback
fallback-profile
authentication fallback
fallback-profile
Allow a single host (client) or multiple hosts
on an 802.1x-authorized port.
dot1x host-mode {single-host
| multi-host | multi-domain}
authentication host-mode
[multi-auth | multi-domain |
multi-host | single-host]
Provides the flexibility to define the order
of authentication methods to be used.
mabauthentication order
Enable periodic re-authentication of the
client.
dot1x reauthenticationauthentication periodic
Enable manual control of the authorization
state of the port.
dot1x port-control {auto |
force-authorized |
force-unauthorized}
authentication port-control
{auto | force-authorized |
force-un authorized}
Set the 802.1x timers.dot1x timeoutauthentication timer
Configure the violation modes that occur
when a new device connects to a port or
when a new device connects to a port after
the maximum number of devices are
connected to that port.
dot1x violation-mode
{shutdown | restrict |
protect}
authentication violation
{protect | restrict | shutdown}
Display 802.1x statistics, administrative
status, and operational status for the switch
or for the specified port. authentication
manager: compatibility with earlier 802.1x
CLI commands
show dot1xshow authentication
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
220 OL-29434-01
Configuring IEEE 802.1x Port-Based Authentication
Authentication Manager for Port-Based Authentication

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C