EasyManua.ls Logo

Cisco Catalyst 2960-XR - Page 295

Cisco Catalyst 2960-XR
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies the port to be configured, and enter interface
configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet2/0/3
Step 2
Use one of the following:
Step 3
Sets the port to access mode.
Configures the Layer 2 port as a private-VLAN host
port.
switchport mode access
switchport mode private-vlan host
Example:
or
Switch(config-if)# switchport mode access
Enables 802.1x authentication on the port.authentication port-control auto
Example:
Switch(config-if)# authentication port-control
Step 4
auto
Specifies an active VLAN as an 802.1x restricted VLAN.
The range is 1 to 4094.
authentication event fail action authorize vlan vlan-id
Example:
Switch(config-if)# authentication event fail
Step 5
You can configure any active VLAN except an internal
VLAN (routed port), an RSPAN VLAN, a primary private
VLAN, or a voice VLAN as an 802.1x restricted VLAN.
action authorize vlan 8
Specifies a number of authentication attempts to allow before
a port moves to the restricted VLAN. The range is 1 to 3,
and the default is 3.
authentication event retry retry count
Example:
Switch(config-if)# authentication event retry
Step 6
2
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29434-01 273
Configuring IEEE 802.1x Port-Based Authentication
Configuring a Restricted VLAN

Table of Contents

Other manuals for Cisco Catalyst 2960-XR

Related product manuals