Cisco Catalyst 2960-XR - Page 334

SUMMARY STEPS
1.
configure terminal
2.
ip admission name name proxy http
3.
interface type slot/port
4.
ip access-group name
5.
ip admission name
6.
exit
7.
ip device tracking
8.
end
9.
show ip admission status
10.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Configures an authentication rule for web-based
authorization.
ip admission name name proxy http
Example:
Switch(config)# ip admission name webauth1 proxy
Step 2
http
Enters interface configuration mode and specifies the
ingress Layer 2 or Layer 3 interface to be enabled for
web-based authentication.
interface type slot/port
Example:
Switch(config)# interface gigabitEthernet1/0/1
Step 3
type can be fastethernet, gigabit ethernet, or
tengigabitethernet.
Applies the default ACL.
ip access-group name
Example:
Switch(config-if)# ip access-group webauthag
Step 4
Configures web-based authentication on the specified
interface.
ip admission name
Example:
Switch(config-if)# ip admission webauth1
Step 5
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
312 OL-29434-01
Configuring Web-Based Authentication
Configuring the Authentication Rule and Interfaces