Cisco SCE8000 GBE - Verifying the Installation

9-21
Cisco SCE8000 GBE Installation and Configuration Guide
OL-19897-02
Chapter 9 Removal and Replacement Procedures
Removing and Replacing Modules
Verifying the Installation
Use the show version command to verify that the system software and firmware are installed properly.
Step 1 From the SCE> prompt, type show version and press Enter.
This example shows the output of the show version command:
SCE8000#>show version
System version: Version 3.5.5 Build 253
Build time: Jun 2 2009, 17:48:38 (Change-list 484251)
Software version is: Version 3.5.5 Build 253
Cryptography class: K9
Hardware information is:
---------------------
Firmware
---------------------
kernel : [kernel] 2.3.0/1 (inactive: [kernel] 2.3.0/1)
u-boot : [uboot] 2.1.0/1 (field: [uboot] 0.8.1/18)
select : [ubs-cf1] 2.3.0/1 (secondary: [ubs-cf1] 2.3.0/1)
---------------------
Slot 1: SCE8000-SCM-E
---------------------
serial-num : CAT1231G03R
part-num : 73-10598-01
cpld : 0x816c
vtpld : 0xc003
summit-0 : 0xf2c1001
summit-1 : 0xf2c1101
dpt/tx : 0x4913
cls/ff : 0x2112
cls cam : 0x454120
cls flow cap: 33554432
ssa : 0x90
---------------------
TVR
---------------------
#cpus : 1
cpu SVR : 0x80900121
cpu PVR : 0x80040202
cpu freq : 1000MHz
cpu (eeprom): 2.1, 1000MHz
cpld : 0xa1bb
cpld-ufm : 0xa803
summit : 0xf2c1701
cf : Model=SILICONSYSTEMS INC 4GB-3213, S/N=B8243186VCK20914MX01,
FwRev=0x242-0230, Size=4125744KB
phy-0 : 0xcc2
phy-1 : 0xcc2
phy-2 : 0xcc2
---------------------
CFC-0
---------------------
board type : P2
#cpus : 3
cpu-0 SVR : 0x80900121
cpu-0 PVR : 0x80040202
cpu-0 freq : 1500MHz
cpu-1 SVR : 0x80900121
cpu-1 PVR : 0x80040202
cpu-1 freq : 1500MHz
cpu-2 SVR : 0x80900121