A-8
Cisco SCE8000 GBE Installation and Configuration Guide
OL-19897-02
Appendix A CLI Commands to Verify a Successful Installation
Basic Post-Installation Checklist
Resulting current shutdown state is off
WAP handling is disabled
show interface linecard connection-mode
sce>show interface linecard 0 connection-mode
slot 0 connection mode
Connection mode is inline
slot failure mode is external-bypass
Redundancy status is standalone
show interface linecard link mode
sce>show interface linecard 0 link mode
Link mode on all links
Current link mode is : crosspath-bypass
Actual link mode on active is : forwarding
Actual link mode on failure is: crosspath-bypass
show interface linecard external-bypass
sce1>show interface linecard 0 external-bypass
External bypass current state is 'not activated'.
External bypass failure state is 'activated'.
Amount of expected external bypass devices: 4 (automatically configured).
Amount of detected external bypass devices: 4
show RDR-formatter
Look for:
• Forwarding mode
• Status (in Status column in the Connection Table)
sce>show RDR-formatter
Status: enabled
Connection is: up
Forwarding mode: redundancy
Connection Table:
--------------------------------------------------------------------------------
| Collector | Port |Status| Priority per Category: |
| IP-Address / | | |------------------------------------------------|
| Host-Name | | | Category1 | Category2 | Category3 | Category4 |
|---------------|-------|------|-----------|------------|-----------|-----------|
| 10.240.59.39 | 33000 | up |100 primary| --- | --- | --- |
| 10.240.59.44 | 33000 | up | --- |100 primary | --- | --- |
---------------------------------------------------------------------------------
RDR: queued: 0 ,sent:60108106, thrown: 0, format-mismatch: 0
UM: queued: 0 ,sent: 0, thrown: 0
Logger: queued: 0 ,sent: 0, thrown: 0
Errors: thrown: 0
Last time these counters were cleared: 07:36:52 EDT TUE April 28 2009
To Next Page
Loading...
