CHAPTER
6-1
Cisco SCE8000 GBE Installation and Configuration Guide
OL-19897-02
6
Cabling the GBE Line Ports and Completing the
Installation
Revised: August 23, 2010, OL-19897-02
Introduction
This chapter provides instructions for cabling the Cisco SCE8000 GBE line ports for single and
cascaded topologies. In a cascade topology, this includes the cascade ports as well as the line ports.
The GBE line ports are located on the SPA modules, which are installed in the SCE8000-SIP module in
slot #3 of the Cisco SCE8000 GBE chassis.
Note When installing a cascaded system, it is extremely important to follow the sequence of procedures
outlined in the section Cascaded Systems, page 6-13.
Note When installing an External Optical Bypass module, the Cisco SCE8000 GBE line ports are connected
to the module. See Cabling the Line Interface Ports: Using the External Optical Bypass Module,
page 6-9 for complete instructions.
• Connecting the GBE Line Ports to the Network, page 6-2
• The Optical Bypass Module, page 6-4
• Cabling the GBE Line Interface Ports, page 6-6
• How to Install a Service Control Application, page 6-13
• Cascaded Systems, page 6-13
To Next Page
Loading...
